Stoneboat head

DAPNET Forums Archive › Forums › Equipment Category › Equipment › Stoneboat head

Viewing 5 posts - 1 through 5 (of 5 total)
  • Author
    Posts
  • September 3, 2013 at 8:44 pm #80947
    Oxhill
    Participant

    Can anyone tell me what the two holes, in the middle of the outer edges, are for??

    September 4, 2013 at 5:30 am #80954
    Donn Hewes
    Keymaster

    I am not sure if it was made for just this, but I would build one row of planks (1″ or 1 1/4″) across the bottom, and then add a 3″ wide or 4″ wide piece on each side. This hole looks like it might fit in that top piece? I wish I had a boat front like that. I made one out of a big piece of pipe. But these have a much better radius. D

    September 4, 2013 at 4:45 pm #80958
    Oxhill
    Participant

    Thanks Donn. It is also interesting that the head doesn’t just have a simple curve to it. It curves up but then has a gentle curve back toward the front. Somewhat shaped like a “S”.

    September 4, 2013 at 5:17 pm #80959
    Oxhill
    Participant

    September 4, 2013 at 9:26 pm #80968
    Mike Rock
    Participant

    How cool. I have the identical head and am wondering the same thing. I was going to mount some vertical iron to make a ‘front’ rail for the stone boat, like on a forecart.

    Mike

  • Author
    Posts
Viewing 5 posts - 1 through 5 (of 5 total)
  • You must be logged in to reply to this topic.